2012 June 01 » Rainy Day Creations

A Tote for Dad and A Winner

Jun 012012

For Father’s Day last year I designed a shirt and tie card. Well using this same idea, I’ve created a shirt and tie tote. This will be filled on Father’s Day with a sweet surprise. However, this tote will comfortably hold 3 or 4 moderately embellished A2 sized cards with envelopes, if you’d rather that than chocolate!

I love suspenders, but I’ve never been able to convince my DH to wear them. Wonder if he’ll even notice them on this little creation. Kinda hard to miss ’em? They carry all the way down the back of the tote as well.

Following is a tutorial for the tote, but first I wanted to announce the winner of my Sketch Challenge. I was SO excited that some of you played along!!! How cool is that. I didn’t use a random generator this time, but instead just wrote your names on some slips of paper, put them in a bowl, closed my eyes and picked one. Congrats, Carol L! I’ll get that gorgeous Graphic45 paper out to you asap!

INSTRUCTIONS FOR A FATHER’S DAY TOTE

Step 1

Cut 2 pieces of cardstock A and B.

Piece A = 7-3/4” x 6-1/2”

Piece B = 6-3/4” x 6-1/2”

Step 2

Piece A – Score in 1” from both long (7-3/4”) sides. Score in 1” from one of the short (6-3/4”) sides.
(This side will now be referred to as the bottom of Piece A and the opposite short side will be referred to as the top.)

Piece B – Score in 1” from both long (6-3/4”) sides and 1” from one of the short (6-1/2”) sides.
(This side will now be referred to as the bottom of Piece B.)

Step 3

Piece A – Measure down 1” from the top and 1-7/8” from both sides and lightly mark this spot. From 1” down on the sides, cut in 1-7/8” to that mark. Cut down 1” from the top on both score lines. This will completely cut away a 1” square from both corners of the top. Cut up 1” from the bottom on both score lines.

Piece B – Cut up 1” from the bottom on both score lines.

Cutting lines are in RED.

Step 4

Follow the instructions on THIS TUTORIAL to make the collar and tie. Note, however, that the “center” should be marked at 3-1/4” (not 2-1/8” as given in Step 3 of the card tutorial.)

Decorate and embellish each piece as desired.

Step 5

Assemble the tote by folding all the scored lines in the same direction and towards what will be the inside of the tote. Adhere A and B together on the overlapping side and bottom pieces. Make sure that Piece A is on the outside of Piece B.